Fitting Rock n Roll bed.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #936
    Sean
    User
    Link: None

    Hi,

    i have just came across the forum and I am looking some advice on installing a RIB 112cm bed in my transit custom. I have seen that there is a kit to purchase for the VW models it is a C channel bar that attaches to the chassis so not just the van floor. For transits I haven’t seen any kit available and a little concerned as my two kids would be in the back this is the reason I purchased the RIB Altair beds as there are tested but have realised that really means nothing if it isn’t fitted correctly. Any advice appreciated.

    Thanks

    Sean

    #1790
    Amanda
    User
    Link: None

    Hello I see this is an old post but have the same concerns. How did you fit the bed in the end?

    #1799
    Kyle
    User
    Link: None

    I got my Rnr fitted by a camper conversion company. They have just used four bolts with a large square washer to spread the load. I have seen the transporter ones though and know what you mean. Could possibly fabricate your own spreader plate

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.